C95900 - Copper Alloys

An American continuous cast high aluminum bronze CuAl12Fe4.This alloy has high hardness and exhibits excellent wear and anti-galling properties. The alloy has limited ductility and is used mainly for wear plates, bending and drawing dies.

Equivalent Specifications

ASTM B505 C95900

Key Features

A high Aluminium Nickel Aluminium Bronze that can be heat treated to produce tensile properties in excess of 830N/mm² with high hardness. Good corrosion resistance.

Typical Uses

Can be used for slow moving heavy duty structural and mechanical parts, including gears, worm drives, valve guides and seats.

Will not tolerate poor lubrication, poor misalignment or dirty lubrication.

In general should be used against hardened steel shafts, both with a fine finish.

Description	Nickel Aluminium Bronze
Nominal Composition	CuAl13Fe4
Alloy Type	cast

Typical Mechanical Properties

Tensile Strength (N/mm²)	550
Proof/Yield Strength (N/mm²)	385
Elongation (%)	1
Hardness Brinell	290
Impact Izod J20°C

Typical Physical Properties

Density g/cm³	7.19
Melting Temperature Range °C	1070 - 1120
Thermal Conductivity W/mK	71.2
Electrical Resistivity μΩ.m15°C
Coefficient of Thermal Expansion 0-250°C
Relative Magnetic Permeability
Coefficient of Friction

Copper Alloys has the ability to modify existing alloys for improved performance. Many customers have benefited from this in the past.

To discuss your requirements, call a member of Copper Alloys’s technical team on +44 (0) 1782-816888, or email [email protected].

This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with tempeter, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.

As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.

Any advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company’s Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions, a copy of which is available on request.