C95520 / C95520HT - Copper Alloys

An American continuous cast nickel aluminum bronze CuAl11Fe5Ni5 primarily used for aerospace applications. This alloy has high strength which is produced by a quench and temper anneal which promotes excellent wear resistance and anti galling properties. This makes it an excellent choice for commercial and military landing gear bushings and bearings. The alloy also meets alternative International specifications, AMS 4881, EN 1982-2008 CC334G, AS 1565 C95810, JIS H 5120 CAC 703 Class 3, SFS 2212 GC CuAl10Fe5Ni5, NF A 53-709 CuAl10Fe5Ni5 Y70, DIN 1714 W Nr 2.0975.04 and GOST 493 BrA10Z4N4L-K.

Equivalent Specifications

ASTM B148 C95520
ASTM B505 C95520
AMS4881
BS EN 1982-2008 GZ CC334G
CuAl11Fe6Ni6-C

Key Features

A heat treatable aluminium bronze. Excellent wear properties, suited for elevated temperature. Heavy duty, high strength alloy with excellent resistance to corrosion and fatigue.

Typical Uses

High strength, high hardness bearings and bushings used mainly for landing gear aerospace applications. Slow moving bearings with good lubrication.

Will not tolerate poor lubrication, or poor misalignment or dirty lubrication. In general should be used against hardened steel shafts, both with a fine finish.

Description	Nickel Aluminium Bronze
Nominal Composition	CuAl11Ni5Fe5
Alloy Type	cast

Typical Mechanical Properties

Tensile Strength (N/mm²)	870
Proof/Yield Strength (N/mm²)	660
Elongation (%)	5
Hardness Brinell	200
Impact Izod J20°C

Typical Physical Properties

Density g/cm³	7.53
Melting Temperature Range °C	1060 - 1075
Thermal Conductivity W/mK
Electrical Resistivity μΩ.m15°C
Coefficient of Thermal Expansion 0-250°C
Relative Magnetic Permeability
Coefficient of Friction

Copper Alloys has the ability to modify existing alloys for improved performance. Many customers have benefited from this in the past.

To discuss your requirements, call a member of Copper Alloys’s technical team on +44 (0) 1782-816888, or email [email protected].

This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with tempeter, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.

As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.

Any advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company’s Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions, a copy of which is available on request.